How To Deal With The Straw Feed Pellet Machine Not Producing Oil?

1. First clean the residual material between the main shaft and the rotor of the feed pellet machine.
2. Clean the filter in the feed pellet machine oil filter.
3. Remove the feed pellet machine refueling grease block, insert compressed air into the oil hole, and clean it with a hollow pipe of diameter (effective length).

1749691381713.jpg

4. Clean the oil in the oil hole, and then clean the oil barrel of the refueling pump.
5. Clean the feed pellet machine grease block, install the grease block, start to oil with a bucket of new oil, and check whether the refueling part is leaking. Check whether the oil seal at the rear end of the rotor is leaking oil, and replace the oil seal if necessary.
6. After refueling for ten minutes, turn on the machine for about five minutes, and then stop the machine until the main shaft is cleaned with new oil.

1749688285564.jpg

View document